Sunday, October 26, 2014
Nokia E73 Power ON OFF Switch Solution
Heres the solution for Nokia E73 Power ON and OFF Switch when damaged. This solution shows the connection line paths of Nokia E73 power switch and can be used where to apply or mend a jumper wire when the power switch terminal solder pads is already lifted or damaged.
Just refer to the solution below and trace the power ON OFF switch tracks.
The Nokia E733 power ON-OFF switch is connected to a 10K resistor this goes through to the power IC (GAZOO). The other terminal side of the 10K resistor is connected directly to the battery supply voltage which is 3.7 volts.
Just refer to the solution below and trace the power ON OFF switch tracks.
Nokia E73 Power ON OFF switch Jumper Ways
The Nokia E733 power ON-OFF switch is connected to a 10K resistor this goes through to the power IC (GAZOO). The other terminal side of the 10K resistor is connected directly to the battery supply voltage which is 3.7 volts.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment